DeWalt DCN662 Manual De Instrucciones página 14

English
Unloading The Tool (Fig. A, I)

WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not in use.
1. Release pusher assembly
force to the nail sticks.
2. Slide nail sticks down and out through the slot in the
rear of the magazine.
3. Open the jam clear latch
there are no nails remaining.
Adjusting Depth (Fig. J)
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel

WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove battery pack.
• Engage trigger lock-off.
• Avoid contact with trigger during adjustments.
1. To drive the nail shallower
adjustment wheel away from the nose of the nailer.
3
2. To sink a nail deeper
wheel 3 toward the nose of the nailer.
Fig. J
13
3
Headlights (Fig. K)
There is a headlight 4 located on each side of the nailer.
Headlights turn on upon battery insertion, activation of
the trigger, or depressing the contact trip. The lights will
automatically shut off after 20 seconds unless tool remains
in use.
Fig. K
4
nOTE: These headlights are for lighting the immediate work
surface and are not intended to be used as flashlights.
lOW BATTERY inDiCATOR: The left-side headlight will
flash four consecutive times and then shut down to indicate
low battery.
12
16 so it is no longer applying
on the nosepiece to verify
5
on the side of the tool.
3
, rotate the depth
, rotate the depth adjustment
JAMMED nAil inDiCATOR: The right-side headlight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
Clearing a Jammed Nail (Fig. A, L)
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
to clear:
1. Remove battery pack from tool and engage the trigger
lock-off.
2. Release pusher assembly and remove any loaded nails
3. Lift the jam clear latch 5
nosepiece door.
4. Remove bent nail, using pliers if necessary.
5. If driver blade is in the down position, cycle the stall
release lever 12 using enough force to fully slide it to
the other end of the slot in the housings.
6. Close the nosepiece door and engage the latch pin
under the two arms on the nosepiece. Push latch until
it locks in place.
7. Reinsert battery pack.
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted.
8. Reinsert nails into magazine (see Loading the Tool).
Fig. L
5
12
nOTE: Should nails continue to jam frequently in nosepiece,
have tool serviced by an authorized D
then pull up to open the
WALT service center.
e