Technical Data; Configuration - Urmet 1158/45 Manual De Instrucciones

ENGLISH
CAPABILITIES
Permits timed opening (from 0 to 99 seconds)
when:
− a user proximity key is placed close to the front
panel;
− the door-release key in the entrance to the
building is pressed.
Each time the door is opened, the 3-digit display,
if enabled, shows the type of activation and the
number of the key that has caused this, according
to the following conventions:
'nnn' number of the user key;
internal entrance button;
key not recognized.
If enabled, the two-color led changes color (from
red to green) to indicate recognition of a proximity
key moved close to the front panel.

TECHNICAL DATA

Power supply: .................................... 12 Vac ±20%
Power requirement: .................................... 310 mA
Operating temperature: ..................... -10 ÷ +50 °C
Door open contact:
Type of contact: .................................C, NC, NO
Max. switchable voltage: .............................30 V
Max. switchable current: ............................3.5 A
Max. load: ......................................40 VA / 25 W
Timing: ................................................... 0 ÷ 99 s
Standard number of user keys
that can be stored: ........................................... 500
Max. number of user keys that
can be stored, after replacement
of the key memory: ......................................... 2000
8
or 10.5 – 15 Vdc
INSTALLATION
Install the device as explained in the attached
diagrams connecting the power supply, the door
opening button in the entrance and the electric
lock.
§
Before completing the push button panel
installation, perform the confi guration.
During installation, always follow the instructions
given below:
− for all connections use cables of suitable cross-
section according to the indications provided in
the system diagrams;
− to power the door open module use SEPARATE
cables from those used to activate the electric
lock according to the instructions given in the
system diagrams.
A SEPARATE conduit should, preferably, be
used maintaining a distance of at least 10 cm
from other conduits.
− after power-on, check that the voltage across
the two power terminals of the Ref. 1158/45
modules is within the prescribed limits.

CONFIGURATION

The device is factory-set to display the user key
number in the door opening phase and for readout
using the two-color led.
− To disable two-color led readout, move the
outermost JP2 jumper from position 'L' (LED) to
position 'NO'.
+/~ -/~ PS+ PS-
− To disable user key number display in the door
opening phase, move the other JP1 jumper from
position 'D' (Display) to position 'NO'.
Proceed as follows:
+/~ -/~
PS+ PS-
ON
NC C NO
ON
NC C NO
DS1148-001A