Troubleshooting Guide - Braun FreeStyle Excel SI 9500 Manual Del Usuario

Vertical steam
Hanging curtains and clothes (jackets, suits, coats) can
be steam-ironed to remove wrinkles. Set the temperature
selector within the red section (d). Hold the iron with
activated steam function in vertical position and pass
over the material in up and down movements.
Caution: The steam is very hot. Never direct the steam
towards a person.
Filling the boiler
Remark: The steam boiler is equipped with a safety cap
(5) which can only be unscrewed after the pressure inside
the steam boiler has reduced to a minimum.
When the steam boiler is empty, the water low indicator
(6,h) will light up. To refill proceed as follows:
• Turn off the switch for the steam function (7,h).
• Press the steam control button (2) until you no longer
hear any steam escaping from the iron.
• Open the safety cap (5) of the steam boiler.
Caution: The safety cap, the steam boiler and espe-
cially the iron stand are hot.
Notice: In case of too much pressure you can't open
the safety cap of steam boiler (5). Wait a moment or
repeat the previous operation.
• Unplug (h).
• Wait 2-3 minutes to allow the boiler to cool down.
• Slowly refill the boiler with water using the funnel (h).
After ironing
• Switch off the appliance by turning off the switch for
the steam function (7) and the on/off switch (8).
• Unplug and let it cool down before storing.
• Water can remain in the boiler.
Maintenance and cleaning
Before cleaning or maintenance always make sure that
the unit is unplugged and has cooled down.
• To clean the sole plate of the iron, use steel wool (i).
Then wipe the sole plate clean with a cloth. Never use
scouring pads, vinegar nor other chemicals. To clean
handle and steam boiler use a damp cloth.
• To maintain efficient performance empty the boiler and
flush with tap water every 1 to 2 months, depending on
the amount of calcium in your tap water.
• Never empty the boiler when the water is still hot.
Trouble-shooting guide
Problem Help
Drops coming When starting or after ironing breaks
out of the steam this is normal (hose is cold – steam
vents condenses). Hold the iron over a cloth
and press the steam control button
until the steam production has nor-
malised.
Select the required ironing tempera-
ture (red section of temperature
selector).
Turn down the steam regulator.
No steam at all Press on the switch for steam
function (7).
Press the steam control button
Remark: Sometimes hot steam is
hardly visible especially when the
room temperature is high or the iron
temperature is near to max.
Less steam Turn up the steam regulator.
develops After pressing the switch for steam
function (7) wait until the orange light
goes off (about 8 minutes).
Check if the water low indicator is on.
Flush the boiler with tap water.
Calcium par-
ticles coming Add distilled water to the tap water.
through the
steam vents
Subject to change without notice.
This product conforms to the European Directives
EMC 89/336/EEC and Low Voltage 73/23/EEC.
At the end of the product's useful life, please
dispose of it at appropriate collection points
provided in your country.
7