Measuring Diodes - Steren MUL-057 Manual De Instrucciones

MEASURING DIODES

1.- Connect the red testing point in the jack signaled "VΩmA"
and the black testing point in the jack signaled "COM".
2.- Set the dial to the range.
3.- Connect the red testing point to the diode to be measured
and the black testing point to the cathode.
4.- The voltage will appear on the LCD screen in m Volts.
MEASURING TRANSISTORS –hFE-
1.- Set the dial to the hFE range.
2.- Determine if the transistor is NPN or PNP and localize the
emitter, base, and collector.
Antes de utilizar su nuevo Kit C
If he does not know the configuration from the transistor,
insert the transistor in hFE jack to show a data on the
screen, the data shown is the hFE of the transistor and in
that position will be the configuration from the transistor.
3.- The multimeter will show the approximate hFE value with
base current condition of 10 uA and VCE 2.8 V.
ENGLISH-09