Refilling The Water Tank - Sharp UA-HD60E Manual Del Usaurio

PREPARATION

REFILLING THE WATER TANK

When using the Clean Air Humidify Mode, or the Clean Ion Shower Mode.
1
①
2
Tighten
3
Click
CAUTION
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water (40 ºC), chemical agents, aromatic substances, dirty water, or other
damaging substances, deformation and/or malfunction may occur.
• Use only fresh tap water. Use of other water sources may promote the growth of mold, fungus and/
or bacteria.
②
③
MAX
②
①
Be sure to remove the power
plug from the wall outlet.
Remove the Water Tank by
pushing the handle down and
pulling it forward.
Fill the Water Tank with tap Water.
CAUTION
• Check to see that there is no water leaking.
• Be sure to wipe off any excess water on
the outside of the Water Tank.
• When carrying the Water Tank, hold it
with both hands so that the Water Tank
opening is facing up.
Install the Water Tank.
Click
E-8