Troubleshooting; About The Product - Sharp UA-KCP100E Manual De Operación

TROUBLESHOOTING

Before calling for service, please review
•
the Troubleshooting list below, since
the problem may not be the product
malfunction.

ABOUT THE PRODUCT

Odour and smoke persists.
• Check the filters. If they appear to be extremely
dirty, clean or replace them.
Air discharged from the product has an
odour.
• Check to see if the filters are extremely dirty.
• Clean or replace the filters.
• Use only fresh tap water. Using other water
sources risks the growth of mold, fungi, or
bacteria.
The product does not operate when
cigarette smoke is in the air.
• Make sure the product is installed in a location in
which the sensors can detect cigarette smoke.
• Check to see if the Sensitive Dust Sensor
openings are blocked or clogged. If they are
blocked or clogged, clean the Sensor Filter or the
Back Panel.
Smell from a new product and/or filter.
• Immediately after removing the plastic bag, a
slight odour may occur. This odour is not harmful
for filter performance or human exposure.
The product makes a clicking or ticking
sound.
• The product may make clicking or ticking sounds
when it is generating ions.
The Cleanliness Indicator is blue even
when the air is not clean.
• The air may have been dirty when the product
was plugged in. Unplug the product, wait one
minute, and then plug the product in again.
The Cleanliness Indicator is red even
when the air is clean.
• Dirty or clogged Sensitive Dust Sensor openings
interfere with sensor operation. Gently clean the
Sensor Filter or the Back Panel.
The Cleanliness Indicator changes colour
frequently.
• The Cleanliness Indicator automatically changes
colour when the Sensitive Dust Sensor and Odour
Sensor detect impurities. If you are concerned
about the change, you can change sensor
sensitivity. (Page 14, 15)
Filter Maintenance Indicator is on.
• Whenever after performing maintenance or
replacing the Humidifying Filter, connect the
power cord to an outlet and then press the Filter
Reset Button for more than 3 seconds.
(Page 18)
The Display goes off.
• When the Light Control is set to "Auto", the light
automatically turns off when the room is dark or
operating in sleep mode. Moreover, when the
Light Control is set to "OFF", the light is always
off. If you do not want the light to be off, set the
Light Control to the "Dim" setting. (Page 14,
15)
The Display does not match weather
report or another hygrometer or
thermometer in the room.
• Outdoor and indoor as well as the home
environment (the volume of traffic nearby, number
of stories in home, etc.) may cause a reading
different than those data.
• There is a difference in the level within the same
room.
The Humidify Indicator on the Display
does not light up when the Humidifying
Tray is empty.
• The room has reached the appropriate level of
humidity and has stopped humidifying.
• Check the Humidifier Float for impurities. Clean
the Humidifying Tray. Make sure that the product
is on a level surface.
The water level in the Humidifying Tray
does not decrease or decreases slowly.
• Check to see if the Humidifying Tray is correctly
installed.
• Check the Humidifying Filter. If the filter is
extremely dirty, clean or replace it.
" " is displayed.
• If the Back Panel is not installed correctly,
" " will be displayed and the operation will be
stopped.
After installing the Back Panel correctly, press
the Power ON / OFF Button to cancel the
" " display.
One of the following is displayed.
• Unplug the product, wait one minute, and then
plug the product in again.
EN-22