Amibot Spirit LASER Manual De Instrucciones página 32

EN
Troubleshooting
Please clean the
05 front bumper
lens
Please clean
06 the anti-drop
sensors
Please put the
07 machine in a safe
place
Please turn on
08
the power switch
Please poke the
09 surface of the
laser sensor
Please clean the
10 laser sensor lens
on top
Please click the
11 start button
again
12 Dust fan fault
The bumper's sensors
are dirty.
Problem with the gap
sensors. The sensors are
dirty.
The robot is no longer in
contact with the ground.
The robot is switched off,
it cannot be charged.
The laser module is dirty.
The laser is frozen.
The button is frozen.
Problem with the fan.
30
Clean the bumper's
sensors using a soft cloth.
Check the gap sensors and
clean them using a soft
cloth.
Place the robot on a flat
surface and restart a
cleaning cycle.
Switch the robot on.
Check the laser and clean
it thoroughly. Be sure
to remove any dust that
could prevent it from
working, using a soft cloth.
Carefully clean the laser
and place the robot on a
flat surface.
Check the button and click
it again.
Turn off the robot and
then let it cool down. Turn
it back on. If the problem
persists, please contact
the AMIBOT after-sales
service.