Dyson AB12 Guia De Instalacion página 5

4. Mark the location on the wall with a pencil.
Use the backplate to mark the locations for the
four fixing points.
5. Drill holes.
6. Fix the optional back panel if required.
3.1
Rear electrical wiring entry.
0.25"
● Primary fixing locations (x4).
Do not use countersunk screws.
Fixing the backplate to the wall.
Fit the backplate securely to the wall using the
appropriate hardware for the wall type and
weight of the unit. Do not use counter-sunk
screws.
Do not secure tightly until after the electrical
wiring has been secured.
Installing the electrical wiring.
1. Cut the entry hole in the rubber grommet
to the correct size: leave a hole smaller
than the diameter of the electrical wiring to
ensure the electrical wiring fits tightly.
5
2. Pull the electrical wiring through the
grommet. Ensure the electrical wiring is
long enough to route correctly through
the backplate to the terminal block. The
electrical wiring must sit in the dedicated
channel.
3. Fit the grommet into the backplate. Ensure it
is secure.
4. Secure the screws in the backplate.
5. Proceed with step 4, 'Connecting to terminal
block'.