Important Safety Instructions - Dyson AB12 Guia De Instalacion

Important safety InstructIons

Before InstaLLInG or usInG tHIs unIt reaD aLL InstructIons anD
customary marKInGs In tHIs InstaLLatIon GuIDe anD tHe oWner's
manuaL
save tHese InstructIons
WarnInG
Installation work and electrical wiring must be done by qualified electrician(s) in accordance
with all federal, state and local laws and applicable codes and standards, including fire-rated
construction.
WarnInG
risk of electric shock! If casing is removed or handled improperly the internal components of the
unit may cause harm or become permanently damaged.
WarnInG
to reDuce tHe rIsK of fIre, eLectrIc sHocK, or InJury to persons,
oBserve tHe foLLoWInG:
Before InstaLLatIon
Before beginning any installation work you must confirm the following:
WIrInG
• Check that the electrical supply corresponds to that shown on the rating plate. If the unit is connected
to any electrical supply other than stated on the rating plate of the unit, permanent damage or
improper/unsafe operation of the unit may result.
• A means for all-pole disconnection must be incorporated into fixed wiring, in accordance with
national and local wiring regulations.
• The unit must be grounded properly.
• When connecting the unit to the electricity supply use electrical wiring in accordance with all federal,
state and local laws and applicable codes and standards, including fire-rated construction
• If electrical wiring entry is to be from the side, it must be secured using plastic or flexible metal conduit
and suitable fittings that lock to the side bracket. The conduit and fittings must be in accordance with
local and national regulations. Solid metal conduit is not suitable.
• Ensure that the conduit and wires are long enough to connect to the backplate and the terminal block.
• When wiring in the back plate the maximum length for the wire's insulation to be stripped back
is 0.25".
• The unit requires a 15 amp circuit breaker with a dedicated line and neutral.
safety
• Isolate the power before installation or service.
InstaLLatIon
• Make sure that the unit is installed in compliance with all building codes and/or regulations.
• The unit must be mounted on a flat vertical wall capable of supporting the full weight of the unit.
• Use hardware as specified in this installation guide.
• Ensure no pipe work (gas, water, air) or electrical cables, wires or ductwork are located directly behind
the drilling/mounting area.
• Dyson recommends the use of protective clothing, eyeware and materials when installing/repairing
as necessary.
• All metal parts in contact with this unit MUST be grounded, including any wall covering.
• Do not use sealant when fixing the unit to the wall.
• To reduce the risk of fire or electric shock, do not use this appliance with any solid-state speed control
device.
Do not use any poWer WasH equIpment for cLeanInG on
or near tHIs unIt.
WarnInG
• To avoid damage to the fascia surface during installation, store the fascia in the original packaging
until it is needed.
LocatIon
• The unit is designed for dry, internal locations only.
• Consult local and national accessibility codes and regulations for relevant installation guidelines.
Conformity and compliance is the responsibility of the installer.
• Ensure the required electrical supply is available for later connection.
• If the unit is to be installed in a location subject to ADA regulations the installer should verify with their
local governing entity to ensure that the unit is installed to ADA guidelines.
• This product is not suitable for mounting onto porous wall surfaces (e.g. drywall) without a
splashback, to avoid discoloring or damage to unprotected walls. (The recommended back panel for
this product is available from Dyson.)
WarnInG
this unit contains substances known to the state of california to cause cancer, birth defects and
other reproductive harm. Wash hand after installation or repair of this unit.
Important
• Please refer to the Owner's Manual for details of the limited warranty.
• Dyson will not be held liable for any damage to property or personal injury as a failure to comply with
the instructions contained herein.
2