Aprimatic 43800/001 Instrucciones Para La Instalación página 10

3.5 Connection to network
The network supply must be: 230V – 50Hz.
Ignition
Attention!
It is necessary to supply the motor connections with an omnipolar device for disconnection from the electric network with a distance
between contacts of at least 3 mm (disconnecting switch, etc.)
4. SYSTEM COMMISSIONING
Attention: the opening/closing limits are memorised in the installed motor and fully mounted roller blind/ awning.
Attention: for the 5-channel radio command, select the desired channel before proceeding with the programming.
Then, proceed just as for the 1-channel radio command.
4.1 One-channel remote control programming procedure
• CMS wireless tubular motor (with emergency manoeuvre function)
Switch in
position OFF
• SMS wireless tubular motor (without emergency manoeuvre function)
Power up: one long beep followed by four
short beeps will be heard and the motor
will turn briefly in
(opening/closing) direction: the motor will
turn up and down once.
4.2 Five-channel remote control programming procedure
Remember to select the required channel using the RIGHT or LEFT button before programming each channel following the method
described above for the SMS and CMS models. The LED corresponding to the selected channel will light up.
Attention: For the 5-channel remote control (43901/005), the LEFT ◄ key (sliding up) and the RIGHT ► key (sliding down) have
the function of channel selection. Using the keys on the remote control (UP-STOP-DOWN), when all 5 LEDs are lit, the opening and
closing can be controlled centrally.
10
230V -
Blue= Neuter
Brown Phase
Yellow/Green= Earth
Power up:
a long beep will be heard.
Within 10 s, press the P2 button twice
and press the UP button once using a pencil.
the UP/DOWN
A beep will be heard each time.
2
3x1.5mm
Within 10 s, press the P2 button twice
and press the UP button once using a pencil.
A beep will be heard each time.
Five beeps will be heard
to confirm programming.
Three beeps will be heard
followed by the motor turning
briefly in the up/down
(opening/closing) directions to
confirm successful
programming: the motor will
turn up and down once.