Problem Resolution - Aprimatic 43800/001 Instrucciones Para La Instalación

4.9 Change of motor rotation direction
After the change of the rotation direction,
the limits end
reprogrammed again.
Ignition
Press the UP key of
the remote control.
The motor will
operate in ascent.

5. PROBLEM RESOLUTION

Problem
At first ignition, the motor functions slowly
or is blocked.
The motor stops in ascent/descent before
the stop limit.
At every ascent command, the motor
moves for a short interval and then
arrests.
6. COMPLIANCE WITH R&TTE 99/05/EC DIRECTIVE
The URMET S.p.A. Company declares that the Wireless Tubular Motors with following codes
Product Code Type model
43800/001 35 SMS 10 Nm
43801/001 45 SMS 20 Nm
43801/002 45 SMS 30 Nm
43801/003 45 SMS 50 Nm
43810/001 45 CMS 20 Nm
43810/002 45 CMS 30 Nm
43810/003 45 CMS 50 Nm
comply with the main prescriptions and with the 1999/5/EC Directive.
The EC conformity certificate can be requested to the Aprimatic Customer Service
stop limits may be
Programming key
Press the Stop
key to arrest the
motor.
Possible cause
• Incorrect power supply
• Erroneous connections
• High load
• Incorrect installation
• Excessive strain
• Thermal protection intervention
The data related to the stop limit and the
position of the table-top conveyor is
damaged.
To restore changes in rotation or direction,
repeat the below operations.
Press and hold the key
located on the motor head
until the latter emits three
beeps and makes a short
rotation.
• Check the plate for the power supply
• Check the circuit and connections
• Check for possible frictions in the
• Re-install the motor
•
•
Follow the procedure for the removal and
reprogramming of the end limit.
Press the UP key of
the remote control.
The motor will
operate in descent
Solution
system an/or the correct choice of the
motor torque with the weight to be
lifted
Check for obstacles in the normal
sliding of the rolling tube
Wait for the motor to cool for
approximately 20 minutes
13