Control Panel Of The Simple Logger ® Ii; Opening The Control Panel - Chauvin Arnoux SIMPLE LOGGER II Manual De Usario

English
♦
Note : The installation of the new driver may take some time. The Windows application may
indicate that it is no longer responding, although installation continues. Leave the installation
enough time to finalize.
12. Once the installation of the drivers is over (a new window informs you that the drivers have been
successfully installed), click on "OK".
13. A new window announces the end of the installation assistance (Installation Wizard Complete); click on
"Finish".
14. The next window prompts you to read the procedure for connecting the instrument to the USB port of the
PC; click according to your choice.
15. Reboot your computer; you can then connect your Simple Logger
16. Once the connection is made, a window announces that the presence of a new item of equipment has
been detected. Let the driver installation process terminate automatically.
Short-cut icons to DataView
♦
Note : If you connect the instrument before installing the software and the drivers, you will
later be obliged to use the "Add / Remove equipment" utility to delete the driver before resuming
the procedure.
2. CONTROL PANEL OF THE SIMPLE LOGGER

2.1 Opening the control panel

To open the control panel of the Simple Logger
Double click on the Simple Logger
figure 2-1)
♦
Note : When you click on the desktop icon and only one instrument is physically connected
to the PC, communication is set up automatically, without the Choice of instrument window
opening.
Page 29
Figure 1-4
®
and each instrument installed are automatically added to your desktop.
®
II:
®
II icon installed on the desktop. A connection window then appears (see
Figure 2-1
Simple Logger
®
II to the USB port of the PC.
®
II DataView
®
II