Description Of The Various Simple Logger; Recording Tab; Configuration Possibilities - Chauvin Arnoux SIMPLE LOGGER II Manual De Usario

®
Simple Logger II DataView

2.3 Description of the various Simple Logger

possibilities
To open the configuration window of a Simple Logger
1. Open the control panel of the Simple Logger
for the opening of the control panel).
2. Then select the Configure line from the Instrument. A configuration dialogue window like the one shown
below (figure 2-3) then open.
♦
Note : The instrument's configuration cannot be changed if it is in recording mode.
Recording must be stopped before any change can be made.

2.3.1 Recording tab

Figure 2-3 shows the first page (Recording):
Storage rate: time interval between recordings of data in the memory of the logger.
Select the desired recording rate from among the values in the list.
Period: Select the desired total duration of recording from among the values in the list.
Start date, Start time: Define the date and time at which recording is to start.
®
II configuration
®
II, proceed as follows:
®
II and connect the instrument (if necessary, refer to § 2.1.
Figure 2-3
English
Page 32