Siemens SITRANS LR 200 Guía Rápida página 10

Hand programmer.
For direct access to SITRANS LR 200,
point the programmer at the
SITRANS LR 200 display and press
the keys. (For detailed instructions,
see the next page.)
Hand-held programmer
max. 600 mm
(2 ft.)
Locking ring
secured by three
2 mm Allen set-screws
Security: (P000: Lock)
Value
Value stored in P069
other
* Factory setting for P069 is 1954: after a new value is entered and accepted, it becomes the
default setting.
Activating SITRANS LR 200
Power up the instrument. SITRANS LR 200 starts in RUN mode.
Notes:
• Keep infrared devices such as laptops, cell phones, and PDA's, away from SITRANS
LR 200 to prevent inadvertent operation.
• The following instructions apply when using the Hand Programmer.
• Do not use the Hand Programmer at the same time as SIMATIC PDM, or erratic
operation may result.
• Press PROGRAM
PROGRAM
• You do not need to key in initial zeros when entering a parameter number: for
example, for P005, key in 5.
Page EN-8 SITRANS LR 200 – QUICK START MANUAL
Key
Display
* Lock off: programming permitted
Lock activated: no changes permitted
then DISPLAY
to return to RUN mode.
Programming Mode
Decimal point
Negative value
CLEAR value
TOGGLE between Units and % on parameter
value
End PROGRAM session and enable RUN mode
Update echo quality parameters
Parameter scroll-up
Parameter scroll-down
DISPLAY opens parameter fields
ENTER the displayed value
Description
to access PROGRAM mode, and press
7ML19985QL81