Nice Neo Tandem M Instrucciones Y Advertencias Para La Instalación Y El Uso página 4

5.4 - Programming limit positions "0" and "1" MANUALLY
Caution! • This programming is recommended for awnings without casings. • The high limit switch (0) or the low limit switch (1) can be memorised at the
beginning according to your needs.
01. Use the Up or Down button to move the awning to the point of mid-travel.
02. Press and hold the Up pushbutton until the awning moves to the required limit position, then release the button.
03. Press and hold the two Up and Down pushbuttons simultaneously until the motor has completed a short down movement, then release.
04. Press and hold the Down pushbutton until the awning moves to the required limit position, then release the button.
05. Press and hold the two Up and Down pushbuttons simultaneously until the awning has completed one short up and down movement, then re lease.
01 02
04
5.5 - Programming limit positions "0" and "1" SEMI-AUTOMATICALLY
Caution! • This programming mode is recommended for awnings with boxes. • Program first position "0" followed by position "1".
01. Use the Up or Down button to move the awning to the point of mid-travel.
02. Press and hold the Up pushbutton until the aw ning stops on impact with limit switch "0"; then release the button.
03. Press and hold the Down pushbutton until the awning moves to the required limit position ("1"); then release the button.
04. Keep the two Up and Down buttons pressed at the same time, until the awning performs a short upward movement. Upon completion, release the two buttons.
01 02
04
5
sec.
3 – English
05
"1"
"0"
1
THE
END
PROCEDURES
03
"0"
1
5
sec.
2
5
sec.
03
THE
END
"1"