Dash Disassembly; Kit Preparation - Metra 95-6541 Instrucciones De Instalación

DASH DISASSEMBLY

1. Unsnap and remove defroster grille at
the top of the dash, and then remove
the (2) Phillips screws exposed.
(Figure A)
2. Unsnap and remove the radio/climate
control panel. (Figure A)
3. Remove the glove box door to access
and remove the (1) 10mm nut securing
the back of radio.
4. Remove the (4) Phillips screws securing
the radio, and then unplug and remove.
Continue to Kit Preparation
2
(Figure A)

KIT PREPARATION

1. Remove the (4) Phillips screws securing
the climate control panel, and then
temporarily move it out of the way in
preparation for the next step.
2. Cut and remove the sub-dash to allow
clearance for the aftermarket radio.
(Figure A)
3. Secure the climate control panel back to
the vehicle using the factory screws.
From the factory radio/climate control panel:
1. Unclip and remove the A/C vents.
(Figure B)
2. Remove the (4) panel clips.
Continued on the next page
Remove
shaded area
(Figure A)
(Figure B)
|
1.800.221.0932 MetraOnline.com