Publicidad
Step 27
Step 26
1
D28
Groove
Insert the DRAWER SIDES (D28 and D29) at an angle
å
into the slot at each end of the DRAWER FRONT (N).
3
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D28
å
and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the
å
groove of the DRAWER BACK (D78).
Repeat this step for the small drawers using parts U, D24, D25,
å
D109, and D716.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
N
D78
D28
D707
VIEW THE T-LOCK BOX VIDEO
2
D28
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D707) into the grooves in the
å
DRAWER SIDES (D28 and D29) and DRAWER FRONT (N).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D29
403793
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D707
D29
N
30S
(12 used in this step)
Page 31
Publicidad
