Kalorik SIS 40516 Manual De Instrucciones página 11

Fax +1 305 430 9692
TROUBLESHOOTING
Problem Possible cause
A white powder This is normal when the
comes out of the iron is new.
soleplate.
Water drips from When you start steam
the soleplate ironing, the steam
while steam connection tube is still
ironing. cold; the iron is not hot
enough.
No steam comes The boiler power switch
out. has not been turned on
or there is not enough
water in the water tank.
No visible steam When ironing at a very
comes out of the high temperature, steam
iron when the may be faint and hard
steam button is to see.
pressed.
The soleplate is Impurities in the water
dirty. adhered to the
soleplate or the
temperature is set too
high for the fabric.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
11
Assembly page 11/40
Solution
The powder is not
harmful and will
disappear after a few
uses.
This is normal; after a
few seconds, the
steam jet will be OK.
You can put the iron
on an old cloth to
start so that the water
is absorbed; set the
iron to a higher
temperature.
Press the boiler power
switch or fill the water
tank and wait until the
indicator light turns
off.
Put a mirror under the
soleplate to check if
steam comes out.
Clean the soleplate
with a soft, damp
cloth; adjust the
temperature to fit the
article of clothing.
SIS 40716 - 120501