Steam Ironing - Kalorik SIS 40516 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fax +1 305 430 9692
FILLING THE WATER TANK DURING USE
When the water tank (1) is empty, the water refill indicator (8) will light
up. Since the water tank is not pressurized, you can refill it during use.
To do so, proceed as described above in the "Filling with water"
section. You can resume ironing immediately.

STEAM IRONING

Before plugging the unit into an outlet, always check that the steam
control trigger (4) is not in locked position.
Fill the water tank as described in the section above with water
and insert the power plug into a wall socket.
As indicated on the temperature dial and in the table on page 6,
steam ironing is only possible at higher ironing temperatures. Set
the dial to
or
Place the iron on the iron rest.
Turn and adjust the temperature control dial until you reach the
steam symbol.
Completely unwind the cord and plug into an outlet.
If you intend to iron with steam, press both switches (9) and (11).
The steam indicator light (12) will be off until the required
temperature is reached. Wait for the light (12) to go on before
steam ironing.
The iron's temperature indicator light (6) will turn on. It will go off as
soon as the desired temperature is reached. During ironing, this
temperature indicator light will come on from time to time. When
this happens, the soleplate is being re-heated to the required
temperature. You can continue ironing while this happens.
Press the steam button (4) to release a burst of steam from the
soleplate of the iron. Release the button and the steam will stop. If
you want a continuous jet of steam, you can hold the steam
button down or slide its purple top part backwards so that the
steam button locks. To stop the continuous jet of steam, push the
purple part of the button forward again and release the steam
button.
You can adjust the steam control knob (10) to regulate the
amount of steam generated by the base. Note: the maximum
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
.
8
Assembly page 8/40
SIS 40716 - 120501

Publicidad

Tabla de contenido
loading

Tabla de contenido