Fax +1 305 430 9692
IMPORTANT SAFEGUARDS
When using your appliance, basic safety precautions should always
be followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE!
2. Use the appliance only for its intended use.
3. Check that your mains voltage corresponds to that stated on the
appliance.
4. To protect against electrical shock, fire or personal injury, do NOT
immerse cord, plugs, base or iron in water or other liquid.
5. The appliance shall be shut-off before plugging or unplugging
from the outlet. Never yank the cord to disconnect form the
outlet; instead, grasp the plug and pull to disconnect.
6. Do not allow the cord to touch the hot surfaces. Let the iron cool
down completely before putting away.
7. Always disconnect the appliance from the electrical outlet when
filling with water or emptying and when not in use.
8. Do not operate the iron with a damaged cord or plug or after the
appliance has been dropped or damaged in any manner.
9. To avoid the risk of electric shock, do not disassemble the iron,
take it to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the
iron is used.
10. Close supervision is necessary when the appliance is used by or
near children. Children should NOT play with this appliance. This
appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
11. Do not leave appliance unattended while plugged in, on an
ironing board, or while it is still hot.
12. Burns can occur from touching hot metal parts, hot water or
steam. Use caution when you turn a steam generator upside
down – there may be hot water in the water tank.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
2
Assembly page 2/40
SIS 40716 - 120501