Kalorik SIS 40516 Manual De Instrucciones página 7

Fax +1 305 430 9692
•
Velvet and other textures that rapidly acquire shiny spots should
be ironed in one direction only (with the nap), applying only light
pressure. Always keep the iron moving on these fabrics.
•
Iron the reverse side of synthetic materials and silk. It is not
advisable to use steam as this may cause stains.
•
When you have been ironing fabrics at a high setting, do not
switch to ironing articles that require a lower temperature
immediately afterwards. Adjust the selector switch to a lower
setting and wait until the iron has cooled to the desired
temperature.
DRY PRESSING (WITHOUT STEAM)
•
Plug the appliance into an outlet. Turn the variable steam dial
(10) to position
•
Press on the iron switch (9).
•
Set the temperature dial for the desired fabric. Always check the
label of the garment before choosing the temperature setting.
•
Leave the iron on its rest and wait until the temperature indicator
light goes out before starting to iron.
•
Leave the steam generation switch (11) in the OFF position.
FILLING THE WATER TANK
•
Put the base on a stable, horizontal, and heat-resistant surface.
•
Open the cap of the water tank and fill the water tank with clear
water up to its "MAX" level. Do not fill beyond this maximum level!
You can use tap water, but we advise you to use distilled water for
the best long-term performance.
•
Close the lid of the water tank.
•
Never add vinegar, detergents, or other chemical products to the
water as this could damage the appliance. See the "Cleaning"
section of this guide for more details.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
.
7
Assembly page 7/40
SIS 40716 - 120501