Yakima LANDING PAD 7 Manual De Instalación página 3

Carefully blow
away debris.
Remove Towers and
assemble Landing Pads.
• Attach rubber pads.
Bolt
Metal
washer
Screw bolt into fastener.
Do not fully tighten.
1033034B-3/12
1033034C-3/12
Seal exposed Make sure top of fastener is
metal with
touch-up paint.
Insert assembled Landing
Pads into fasteners.
Attach SkyLine or
Control Towers and
finish tightening bolts.
flush with rooftop.
Refer to your SkyLine or
Control Tower instruction
to fully tighten Towers.
Apply a silicone
WARNING:
bead over the holes.
Direct contact of uncured
sealant irritates eyes and may
irritate skin. Overexposure
to vapor may irritate eyes,
nose and throat. Avoid eye
and skin contact. Use with
adequate ventilation. Do not
handle contact lenses with
sealant on hands. In case
of eye contact, flush with
water for 15 minutes. Obtain
medical attention. In case of
skin contact, remove from skin
and flush with water. Sealant
releases acetic acid (vinegar-
like odor) during cure.
Note: orient fasteners
to avoid obstructions.
Firmly close
covers.