Technical Specifications; Maintenance And Cleaning - THOMSON MIC150i Manual Del Usuario

USING
listen for iPod/iPhone:
• Connect the iPod/iPhone docking station.
• Press q twice to turn on.
• Press SOuRCE to switch to iPod/iPhone, the tracks are
played automatically.
• To pause/resume playback, press 12.
• To access a track, press { or }.
• To fast forward or rewind during playback: { or } hold
down and release to resume normal playback.
• To stop playback, press 12.
• To return to the previous menu navigate the menu of
the iPod/iPhone, press mEmORY/mENu on the remote
control.
• Use w ou s to scroll through the menu of the iPod/
iPhone, press PROG/SElECT on the remote control to
enable and start reading.
Charging iPod/iPhone
When the unit is turned on, the iPod/iPhone placed on the
dock to start charging.
uSING THE RADIO
• Turn the appliance on and press SOuRCE to select the
« TuNER » function.
• Tune the radio to the desired station using 5 or 6: the
frequency is displayed on the LED screen.
• Press successively 5 or 6 to select an FM station.
• Press 5 or 6 for 2 seconds on the device or 2 times on
the remote control to scroll through frequencies, then
release to trigger automatically on the nearest station
received.
• To turn the radio off, press q.
Note : For improved reception, unfurl the FM wire aerial (K)
located at the rear of the appliance.
PROGRAmmING RADIO STATIONS
Manual programming:
• Select a station to be saved.
• Press mEmORY/mENu on the remote control: program
mode (P- 01) is displayed.
• Press w or s top selects a number.
• Press mEmORY/mENu on the remote control to save
each station (20 maximum).
• View the programmed radio stations using w or s.
Automatic programming:
Press mEmORY/mENu on the remote control for 3
seconds: programming will launch automatically and
memorize received stations.
Accessing saved stations:
• Press w or s to access the saved stations.
HEADPHONE SOCKET
Headphones (not provided), fitted with a Ø 3.5mm jack and
not exceeding 100dB can be connected to the appliance.
• Connect the headphones to the socket (I).
Note: When the headphones are connected, the loud
speakers are automatically inactive.
Use the appliance at a comfortable volume to preserve user
health.
EN 12
MICRO SYSTEM
MIC150i

TECHNICAL SPECIFICATIONS

• Remote control power source: 1 CR.2025 3V lithium
mini battery (included).
•Mains adapter: Input: 100-240V ~ 50/60Hz - 0.8A /
Output: 9V/3000mA.
• Frequency range: FM: 87.5 - 108.0 MHz
• Consumption: 20W maximum
Note: Unit design and specifications are subject to change
without notice. The manufacturer reserves the right to make
the necessary improvements.

MAINTENANCE AND CLEANING

Consult the following table if there is a problem with the
appliance.
mAINTENANCE AND ClEANING
• Unplug the appliance before cleaning it.
• Remove fingerprints and dust with a soft and slightly
damp cloth. Do not use abrasive products or solvents
that may damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or
in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance
and remove the batteries.
is a trademark of TECHNICOLOR S.A. used
under license by:
Parsons International France - 19 Boulevard Albert Einstein
77420 Champs sur Marne - France
N°Azur (+33 ) 0825 745 770
Monday to Thursday (from 9 am to 18 pm) and Friday (9 am
to 3:30 p.m.)
www.thomsonaudiovideo.eu
call rate according to operator