Schumacher Electric PBI2212 Manual Del Usuario página 57

Ocultar thumbs Ver también para PBI2212:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Model SCI200B Charger
14.
CHARGER SAFETY AND OPERATING INSTRUCTIONS
Contact the equipment
supplier for details on
how to properly dispose
of this product within
a specific country, per
WEEE requirements.
IMPORTANT
14.1
Read the entire manual before using this product. Failure to do so could result in serious
injury or death.
14.2
This charger is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the charger by a
person responsible for their safety.
14.3
Children should be supervised to ensure they do not play with the charger.
RISK OF EXPLOSIVE GASES. PREVENT FLAMES AND SPARKS. PROVIDE
WARNING
ADEQUATE VENTILATION DURING CHARGING.
14.4
during use.
14.5
metal or concrete.
14.6
To reduce the risk of a battery explosion, follow these instructions and those published
by the battery manufacturer and the manufacturer of any equipment you intend to use in
the vicinity of the battery. Review the cautionary markings on these products and on the
engine.
14.7
Digital Display on the Booster
To check the internal battery's charge status, either press the Battery Status button to
get the percent of charge or turn the ON/OFF switch to the ON position to get the battery
voltage. Charge the internal battery if the display shows it is under 100%.
When connected to the vehicle, the display shows the vehicle's battery voltage. When
connected and in the ON position, the display shows the equalized voltage between the
vehicle's battery and the internal battery.
NOTE: The internal battery's charge status is most accurate when the booster has been
disconnected from all devices and charging sources for a few hours.
14.8
LED Indicators on the Charger
CHECK BATTERY
connected to the battery. If the charger does not detect a properly connected battery,
the CHECK BATTERY LED will light. Charging will not begin if the CHECK BATTERY
LED is on.
Read manual
before using.
Class II Charger
Charge Booster immediately after purchase, after each use and every
30 days to keep the booster's internal battery fully charged. Never wait
until the Booster is completely discharged before recharging.
The charger and booster must be placed in a well-ventilated area
Make sure to place the charger on a dry, non-flammable surface, like
(red) LED lit: Indicates that the charger is not properly
Caution,
Warning
risk of electric
shock.
57
Do not
For indoor
expose
use only.
to rain.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pbi3612Pbi3624Pbi4424

Tabla de contenido