Tools You Will Need; Mounting Space - Monogram ZSA1201 Instrucciones De Instalación

TOOLS YOU WILL NEED

# 1 and #2 Phillips
screwdriver
Tin snips (for cutting
damper, if required)
Gloves
Safety goggles

MOUNTING SPACE

16-
1 4
from the floor
to the top of
the oven
49-40650-3
Installation Instructions
Pencil
Scissors
(to cut template, if
necessary)
Saw (saber, hole or
keyhole)
Bottom edge of
cooking surface
min.
2
Backsplash
Ruler or tape
measure and
straight edge
Electric drill with
3 16
1 2 5 8
Stud finder or
Level
NOTES:
•
wide and free of obstructions.
• If the space between the cabinets is greater than
gap between the oven and the cabinets. Your
cabinet needs
Owner's Manual contains the kit number for your
model.
more from the
• This oven is for installation over ranges up to
• If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions
on the top cabinet template for power cord
clearance.
• * 13" max: for standard installation, 15" cabinet
depth requires additional steps using an
additional installation kit JX15BUMPWW/BB.
• For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the
vent.
• The product should not be installed over any
cooktop or range with a combined BTU greater
than 60000 BTU.
Carpenter square
(optional)
7 16
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed
bottom cabinet
installations only)
Hammer (optional)
Duct and masking tape
7