Determining Wall Plate Location - Monogram ZSA1201 Instrucciones De Instalación

DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET
C
Plate position – beneath flat bottom
cabinet
Plate position – beneath recessed bottom
cabinet with front overhang
49-40650-3
Installation Instructions
Mounting Plate Tabs
Touching the Cabinet
Bottom
Mounting Plate
with Tabs Below
Cabinet Bottom the
Same Distance as
the Front Overhang
Depth
Plate position – beneath framed recessed
cabinet bottom
Your cabinets may have decorative trim that interferes
with the oven installation. Remove the decorative trim
to install the oven properly and to make it level.
THE OVEN MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no
back or side frame, install the mounting plate down
the same distance as the front overhang depth. This
will keep
the oven level.
1 Measure the inside depth of the front overhang.
Draw a horizontal line on the back wall an equal
2
distance below the cabinet bottom as the inside
depth of the front overhang.
3
For this type of installation with front overhang only,
align the mounting tabs with this horizontal line, not
touching the cabinet bottom as described in Step D.
Mounting Plate
Tabs Touching the
Back Frame
9