Electrical Connection - Cata & Can Roca IDB 6003 PRO BK Instrucciones Para La Instalación, El Uso, El Mantenimiento

EN
INSTALLATION
All operations relative to installation (electric connection) should be
carried out by skilled personnel in conformity with the rules in force.
These Instructions are for the qualified technician, as a guide to installation,
adjustment and maintenance, according to the laws and standards in
force. These operations must always be carried out when the appliance
has been disconnected from the electric system.
Glue the gasket supplied on the entire perimeter, on the bottom of the
glass.
The appliance is intended to be installed as indicated in figure 22.
Do not install the hob over an oven; in case you do, make sure of the
following:
- The oven is equipped with an appropriate cooling system.
- There is no warm-air leakage from the oven towards the hob.
- Suitable air-inlets are provided as shown in the figure 22.

Electrical connection

This appliance is supplied with a power cable with 5 wires coloured as
follows:
-Brown = L1 (phase)
-Black = L2 (phase)
-Blue = N1 (neutral)
-Grey = N2 (neutral)
-Yellow/Green = (earth)
Connect to the mains according to figure 23.
23