Technical Information; Installation Considerations - Hansgrohe Talis Select 72419 1 Serie Instrucciones De Montaje / Manejo / Garantía

English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp. 120° - 140° F*
Max. hot water temp
Flow rate - handshower
71744xx1, 32327xx1, 1.8 GPM (6.8 L/min)
72414xx1, 31527xx1, 32557xx1
31404xx1, 31433xx1, 1.75 GPM (6.6 L/min)
31408xx1, 32557xx1, 74555xx1
71748xx1, 32314xx1,
72419xx1, 31444xx1, 31446xx1,
31448xx1, 31733xx1, 32553xx1,
74553xx1
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The four-hole trim sets require rough 06646000
(not included). The three-hole trim sets require
rough 06607000 (not included).
• Four-hole models only: Protection against
backflow is provided by a check valve in the
handshower elbow and by an automatically
resetting diverter.
• 1.75 GPM models only:This showerhead
is for use with an automatically compensating
valve rated at 1.3 GPM (4.9 L/min) or less.
• 1.8 GPM models only:This showerhead is for
use with an automatically compensating valve
rated at 1.4 GPM (5.3 L/min) or less.
2
15 - 75 PSI
145 PSI
176°F*
2.0 GPM (7.6 L/min)
• 2.0 GPM models only: This handshower
is for use with automatic compensating valves
rated at 1.5 GPM (5.7 L/min) or less.
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or
other approved anti-scald device.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no
higher than 112°F (44°C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.