Publicidad
FACE FRAME CABINETS
Install bottom slide
1)
Attach feet (#9) to bottom slide (C) using M4 screw (#8) as shown
in gure 1. To attach the rear foot, the soft-close will need to be
removed rst as shown, then re-attached afterwards. You will need
to remove the inner member(s) from the slide so you have a hollow
channel when attaching the feet.
g. 1
C
2)
front of the slide with the front of the face frame and center the slide
in the cabinet. Attach to the oor using screws (#7). When using the
template to align the pilot hole, be sure to fold across the dotted line
on the front of the template to wrap over the face frame or front end
of the frameless cabinet. This will keep your slide from being installed
too far back into the cabinet. See gure 2.
C
g. 2
Insert pantry frame
5)
The bottom of the frame (A) sits on top of the bottom slide (C) as
shown in gure 5. Use M6 screw (#2) and washer (#3) to attach.
A
6)
Slide the top portion of the frame up so that the top slide is
concealed but not touching the wood cabinet.
7)
Two pins in top slide (B) insert into mating bushings in the top of
the frame (A) as shown in gure 6.
B
pilot holes. Roughly align the
3
g. 5
C
g. 6
A
Install top slide
3)
The top slide (B) of the pantry needs to be mounted ush with the
face frame. It will likely be necessary to cut and attach a spacer board
as shown in gure 3.
g. 3
Top Spacer
Must be ush with Face Frame
4)
Using
Roughly align the front of the slide with the front of the face frame
and center the slide in the cabinet. Attach to the spacer board from
step 3 using screws (#6).
g. 4
B
8)
Tighten the two screws in gure 7.
A
pilot holes.
UNIT : inch (mm)
g. 7
Publicidad
