Publicidad
Adjustment
15)
The rst adjustment is the left to right tilt. By tightening the
front screw and loosening the back screw, the door will tilt out
on the left. The reverse is true if you loosen the front screw and
tighten the back screw, the door will tilt out on the right. Once you
get this tilt adjustment correct, tighten the center screw both top
and bottom. Now snap on the logo cap (#4) to cover this hardware
on the top. See gure 13.
16)
The next adjustment is left to right. Loosen two screws on
each T type door mount bracket. Slide the door left to right so
that the overlay is the same on both sides. Tighten both screws
on each bracket. Once this adjustment is nal, use two (#7) screws
to lock the door in place. Refer to gure 14
Install baskets
18)
Install top basket rst. Position it inside the frame and
hold it to the top. Snap plastic basket clips (#5) onto the frame
as shown in gure 16. Then slide the basket down on the clips.
19)
Con rm desired spacing, snap in all the clips and attach
remaining baskets.
g. 16
g. 13
g. 14
F
17)
nal adjustment is top to bottom and tilt. Loosen the
The
two M6 (#2) screws. Using the 4mm allen wrench (#1), tighten
the front screw and loosen the back screw to tilt the top of the
door out. If you loosen the front screw and tighten the back
screw, the top of the door will tilt in. If you need to adjust the
whole door down, tighten both screws the same amount.
Finish by tightening the two M6 (#2) screws. Refer to gure 15.
g. 15
F
Install remaining door mount bracket(s)
20)
Attach the remaining door mount bracket(s) (E) as shown
in gure 17. The pilot holes you drilled in step 13 should align.
It is important that this door mount bracket t closely under a
basket so that it does not get in the way of storage.
g. 17
E
F
Publicidad
