Timer Function; Cleaning And Maintenance; Cleaning The Appliance - Silvercrest SLR 30 A1 Instrucciones De Uso E Indicaciones De Seguridad

Timer function

You can use the timer function to set the operating time of the appliance to be-
tween 1, 2, 4 or 8 hours. After the set operating time has elapsed, the appliance
turns off automatically and switches to standby mode. To set the timer function,
proceed as follows:
During operation, briefly press the timer button
function. Then press the timer button
set the required operating time (1 hr, 2 hrs, 4 hrs, 8 hrs). The set operating time
is displayed on the control panel
To deactivate the timer function, press the timer button
(if necessary) during operation until the operating time display (1 hr, 2 hrs,
4 hrs, 8 hrs) goes out and the timer button
NOTE
► When the appliance is switched off, the last selected settings of all
functions are saved. These are then used when the appliance is switched
on again. If you disconnect the appliance from the power supply, the last
selected settings are deleted.

Cleaning and maintenance

Cleaning the appliance

RISK OF ELECTRICAL SHOCK!
► Switch the appliance off and pull out the mains plug before cleaning the
appliance!
ATTENTION! PROPERTY DAMAGE
► Do not use caustic, abrasive or solvent-based cleaning materials. These can
damage the surfaces of the appliance.
Clean the appliance with a dry or slightly moist cloth. For stubborn soiling, use
a little mild detergent on the dampened cloth.
Clean the ventilation openings carefully and regularly with a suitable soft brush
to remove dust and dirt.
SLR 30 A1
2
once to activate the timer
2
briefly, several times if necessary, to
1
and the timer button
2
is no longer illuminated.
2
lights up.
2
briefly several times
GB │ IE │
11 ■