us_main.book.book Page 47 Tuesday, September 1, 2020 5:54 PM
Performance
Problem
Odor
The previous cycle was stopped before completion and residual water remains in the
dishwasher.
• Turn on the power, run the Cancel cycle option to remove the residual water, then run the
There is food in the bottom of the unit or in the filter.
• Clean the filter and the interior according to the Maintenance section of the owner's
Unwashed dishes are left in the unit for a long time.
• Run a cycle with one cup of white vinegar in a dishwasher safe glass or bowl placed on the
Food soil remains on
Improper cycle selection.
dishes.
• Select correct cycle based on soil level and type of dishware being washed.
Water temperature is too low.
• Check water supply connection or water heater setting.
Dishwashing detergent was not used.
• Use recommended detergent.
Low inlet water pressure.
• Water pressure should be between 20 and 80 psi.
Water jet holes on spray arms blocked.
• Clean the spray arms.
Improper loading of dishes.
• Make sure dishes do not block spray arm rotation or interfere with detergent dispenser.
Filters are clogged.
• Clean filters.
Cloudiness on
Combination of excessive detergent and hard water.
glassware.
• Use less detergent and use a rinse aid to minimize the problem.
Black or gray marks
Aluminum items rubbing dishes during cycle.
on dishes.
• Reposition the dishes.
Yellow or brown film
Coffee or tea stains.
on inside surfaces of
• Eliminate the stain by using a stain removal product.
dishwasher.
Turbo cycle using detergent but with the dishwasher empty.
manual.
upper rack. (Vinegar is an acid, and with constant use it could damage your appliance.)
TROUBLESHOOTING
Possible Cause & Solution
47