Activating The Outputs; Activating/Deactivating Automatic Outputs; Activating/Deactivating Remote-Control Outputs; Remote Activation And Deactivation Of The Outputs - DSC GS3100 Manual Del Usario

Tabla de contenido

Idiomas disponibles

This Communicator has 3 outputs programmable as Automatic (outputs with this attribute will activate in response to the

associated events) or Remotely, through receiving a telephone call from a previously programmed number.

The T1,T2 and T3 Open Collector outputs can be activated automatically by the following events:

T1, land line trouble (line down)

T2, GSM Network trouble (Limited/No Service)

T3, caller identification

, , , , , Once an output has been activated automatically, it will not restore its state until all the causes of activation clear.

The T1 and T2 Open Collector outputs as BISTABLE, while the T3 output is MONOSTABLE (Once a Monostable output

has been activated, it will not deactive until On Time expires).

The Monostable T3 output may be activated as follows:

1. By sending a cost-free call from a preset Remote Control number. This Device will activate the output concerned

without answering the call.

The ON time may be set to a period of time between 1 and 86400 seconds, in steps of 1 second.

, , , , , For proper function of this Device, use a 32 K SIM CARD (or higher).

For the programming using the PC-Link cable (see Fig. 6) must be connected to the Connector [9] of the Communicator and

a COM port on the PC; the GS3100 Console application is also required.

Once the PC-Link cable has been connected, set the computer COM port through the Options->Serial ports

Fig. 6 - Diagram of the PC-Link connection cable

GS3100

ACTIVATING THE OUTPUTS

Tabla de Contenido

Tabla de contenido