Led Light - koban KCTE-80 Manual Del Usuario

KCTE-80
Thermal Imager
6.5-Focus
To adjust focus, clockwise or Anti-clockwise rotates the IR Lens. When target comes into focus, it shows a
sharper image. When the target moves out of focus, the thermal image becomes blurry.
Note
Correct focus is important in all imaging applications. Correct focus makes sure that the infrared energy is
correctly directed onto the pixels of the detector. Without the correct focus, the thermal image can be blurry and
the radiometric data will be inaccurate. Out-of-focus infrared images are frequently unusable or of little value.
6.6-Shutter
The thermal image of the Thermal Imager becomes blurry, when the Thermal Imager no correcting after
some minutes or the Thermal Imager changes target. To get fine thermal image, the Thermal Imager need to
correct.
The Thermal Imager has two mode for correcting, Manual and Auto Mode. In Manual Mode, push the Power
button, the Thermal Imager will correct. In Auto Mode, the Thermal Imager can correct automatically while The
thermal image of the Thermal Imager becomes blurry .
6.7-Zoom
Thermal Imager offers 1-32x continuous zoom functions.
1-In desktop, press the up button, image zoom out 1 0%, long press
will continue to zoom out.
2-In desktop, press the down button, image zoom in 10%, long
press will continue to zoom in. When zoom in or zoom out, the zoom
factor "1X" displays in the upper status bar.

6.8-LED Light

1-In desktop, press the right button and hold about 2 seconds, the LED light is on.
2-In desktop, press the right button and hold about 2 seconds again, the LED light is off.
6.9-Laser
1-In desktop, press the left button and hold about 2 seconds, the laser is on.
2-In desktop, press the left button and hold about 2 seconds again, the laser is off.
www.grupotemper.com