Operating Guidance; Reading Hold; Relative Measurement; Manual Measuring Range Choice - koban KPA 02 Manual Del Usuario

Operating Guidance

Reading Hold

• In the process of measurement, if reading hold is required, press "HOLD"
key, the value on the display will be locked.
• Press HOLD key again to cancel reading hold.

Relative measurement

• Relative measurement only can be used to measure current, voltage,
resistance, capacitance and temperature.
• Press the "REL" key to enter relative measurement mode. The automatic
measuring range will be disabled. Press "REL" key again to restore
automatic measuring range.
Note: When measuring, to use relative measurement, input corresponding
measuring range first through the probe.

Manual measuring range choice

Use RANGE key to select automatic or manual measuring range. The preset
selection is automatic measuring range.
Press to switch to manual measuring range. In the manual measuring range
mode, click once to change to a higher grade, and click again to change to
the top grade. Continue to press this key to change to the bottom grade.
If this key is pressed more than 2 seconfs, the meter will switch back to the
automatic measuring range.

Function switch

• In the DC current measurement state, press the "FUNC" key, and the
meter will enter AC current measurement state. Presses "FUNC" key
again, and the meter will enter DC current measurement state again.
• In the resistance grade, press the "FUNC" button to switch among
resistance, diode and continuity detection.
Back light and clamp head light
• In the process of measurement, if ambient light is too dark to read, press
key to turn on the backlight. The backlight will automatically turn off
after about 30 seconds.
• During this period, pressing
• In the current grade, the meter will turn on backlight and clamp head light.
www.grupotemper.com
key will turn off backlight.
KPA 02
Digital clamp meter
Instructions manual | 29