Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Ingeteam
1.
Use the template supplied with the combiner box to mark the holes to be made in the wall, always
respecting the distances regarding the inverter anchor points. Drill the necessary holes.
2.
With the combiner box open (see "5.2. Opening the housing"), follow the points below for each of the two
rear plates.
3.
Unscrew the two side screws.
4.
Remove the plate.
16
Installing the unit
ABI2015IQM03_ - Installation manual
Publicidad
Capítulos
Tabla de contenido
