Technical Data - Beaba BABYCOOK Folleto De Instrucciones

CLEANING
• Always unplug the appliance before you start cleaning it.
• Immediately rinse the accessories that have come into contact with the food
under running water to prevent germs forming.
• Descale the heating reservoir regularly using white vinegar only. Ensuring the device
is cold and not connected to the mains, pour a mixture of 100ml of water and 100ml of white
vinegar into the heating reservoir. Leave for the night and then empty. Repeat the operation if
necessary until all the lime has been removed. Connect the device to the mains and then
complete two heating cycles using water only in the heating reservoir (3 measures - 150 ml) in
order to rinse it well. Then clean the bowl and accessories with warm, soapy water.
Never use a chemical descaler or a coffee machine descaler in the heating reservoir.
• After you have cleaned the blade, make sure
that the gasket is properly back in place.
• Babycook accessories are not suited to
sterilisation.
RECOMMENDATIONS
• Your device is designed for domestic use only.
• Before use, always ensure that all the different parts of the device have been installed properly.
• Do not place the device on a hot surface, near a naked flame or a source of water.
• The mixing blade must always be placed in the jug in cooking mode and mixing mode.
Never put the bowl on the pedestal without the blender cutter in place.
• Do not move the appliance or put a cover over it while in use.
• Never immerse the electrical pedestal unit in water.
• Do not fill the bowl above the mark lines and do not add water to the jug before mixing.
There is a risk of very hot liquid being splashed when mixing.
• Keep the BABYCOOK out of children's reach and always lock the bowl lid fully so that the
blade is inaccessible.
• Use the BABYCOOK on a flat surface and stable.
• Plug the Babycook into an earthed 220V socket. Check that the power supply for your device
is suited to your electrical installation. Unwind the power supply lead. Do not use an
extension lead. As a safety measure and in order to avoid accidents, if the power cable is
damaged, have it replaced by the Beaba after-sales service or by its certified national
representative. Any connecting errors cancel the guarantee.
Placing the gasket on the blender cutter
12 12 12
• Do not run the BABYCOOK in cooking mode when the reservoir is dry.
• Never unlock the jug from the base until the cooking light has been switched
off and before the device has cooled completely.
• Never open the reservoir lid until the device has cooled completely.
• Regularly check that the steam outlet hole on the bowl is not blocked.
• Never lean over the steam outlet hole during the cooking cycle (risk of scalding).
• Handle hot parts with great care.
• Regularly de-scale the heating reservoir.
• Use only water or white vinegar (for descaling) in the heating reservoir. Never put food, salt
or any other non-recommended elements in the heating reservoir.
• Never leave water in the reservoir. Empty any leftover water after each use.
• Unplug the device when you have finished using it, when you are cleaning it, or when you
are handling the blade. Do not unplug by pulling on the lead.
• Do not use your device if it is not working properly or if it is damaged. In this event, contact
Beaba's after-sales service directly or its certified national representative.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.

TECHNICAL DATA

Voltage: 220 - 240 V ~ / 50-60 Hz
Power: 380 W (130 W motor)
The logo on this product featuring a crossed out wheelie bin indicates
that the product must not be disposed of with your other household
waste. In order to prevent damage to the environment or human health,
please separate the product from other waste in order to ensure that it
is recycled in a manner that is safe for the environment. For further
information about existing collection sites, please contact your local city
office or the shop where you purchased the product.
13 13 13