Cequent Performance Products 118624 Instrucciones De Instalación

Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
Range Rover Evoque
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l'installation. Durant
l'installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
118624-037 Rev. A 2/4/2014
d
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, Drill (3/32" Drill Bit),
Philips Head Screwdriver, Test-probe
1. Locate the vehicle's towplug located under
the vehicle on the passenger side. Locate the
opening to the right of the vehicle muffler.
Reach up into opening to locate the vehicle's
grey towplug
d
protective cover and discard. Connect the
towplug harness into mating harness.
Check to see that the mating surfaces of
the wiring connectors match. All connector
surfaces should be clean and free of dirt.
WARNING
All connector surfaces should be clean and
free of dirt. Be careful not to damage the
locking tabs and be sure that connectors
are fully inserted with locking tabs in place.
. Disconnect the mating
PAGE 1 OF 3
2. Locate a suitable grounding point. Drill a
3/32" hole and secure the white wire using
the eyelet and screw provided. Do not drill
into any exposed surfaces.
CAUTION
Verify what is behind any surface prior to
drilling to avoid damage to the vehicle and/
or personal injury. Do not drill into any
exposed surfaces.
3. Mount the 4-Flat end in an accessible location
with a bracket or electrical box (not included).
WARNING
Overloading circuit can cause fires. DO NOT
exceed lower of vehicle manufacturer rating or:
• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.