Programming The Controller; Moving About The Display; Set Clock And Day; Set Station Run Time, Cycles, And Days Apart - Hunter PSCZ 601-Z Manual Del Usaurio

PROGRAMMING THE PSC-Z CONTROLLER

Moving About the Display .................................

Use the four buttons in the center of the control panel to move
about the display:
LAST
Press to move from field to field.
The active field flashes.

Set Clock and Day ............................................

TIME
Press
DAY
• Set time and day before
setting up watering schedules.
• Set time to AM, PM, or 24-hour.

Set Station Run Time, Cycles, and Days Apart .....

Press
STATION
For each station,
you can set:
• Cycle length
(from 1 min.
to 3 hrs., 59 min.)
• The PSC-Z waits at least 30 min. between cycles to allow water to soak
into the soil. To change the automatic cycle delay time for either program,
hold down START TIMES for 4 secs.
• Set all cycle times to zero on unused stations.
• You can enter new station settings at any time, even while water is running.
• The PSC-Z has a supplied schedule that it will run if you do not set one
up, or if power is lost, there is no battery, and the internal power storage
capacity is exhausted (after 10 hours without power or backup battery).
Program
A
B
56
NEXT
• Number of
Cycle Cycles
Time per Day
10 min.
1 min.
LAST
Press to change the flashing value,
or to select days.
To display:
To display:
STATION
PROGRAM A
NEXT WATER WED
cycles per day
(from 1 to 14)
Days
Apart
1 1
1 1
NEXT
AM
SUN
CYCLES
PER DAY
DAYS
APART
CYCLE TIME
• Days between
waterings
(from 1 to 14)
Start Cycle
Time Delay
1 am 30 min.
0:FF 30 min.