Electromagnetic Compatibility; Intended Use; Safety Instructions - Flex ALC 311 Manual Del Usaurio

Electromagnetic compatibility

Although the power tool satisfies the strict
requirements specified in the relevant
directives, it cannot be excluded that the
power tool
– will affect other power tools (e.g.
navigation equipment on aircraft) or
– itself will be affected by high radiation,
resulting in a malfunction.
In these or other uncertain cases, check
measurements should be taken.

Intended use

This line laser is designed for industrial
applications.
The power tool is designed to determine,
transfer and check horizontal courses, vertical
lines, alignments, perpendicular points and
right angles, e.g.:
– to transfer metre and height cracks,
– to mark partition walls (vertical and/or
at a right angle) and
– to align equipment and controls in three
dimensions.

Safety instructions

Danger!
– Keep children away from laser power
tools.
– Use suitable measures to prevent a third
party from looking into the laser beam
with optical instruments.
– If at all possible let the laser beam path
run above or below eye level.
– It is not permitted to tamper with or
change the power tool. Do not disable
safety devices and do not remove
information and warning signs.
12
– Before switching on the power tool,
check for visible damage. Do not switch
on damaged power tools.
– The power tool may be repaired by
authorised technicians only. If the power
tool is opened without authorisation,
laser radiation may be emitted which
exceeds class 2.
– Do not use the power tool in an explosive
environment.
– If carrying out alignment work on ladders,
avoid an abnormal posture. Ensure that
you have a secure footing and keep your
balance.
Damage to property!
– When transporting the machine, always
lock the machine foot/compensator
clamp (10).
– Do not use the machine in the rain.
– If the power tool is brought from a cold to
a warm environment or vice versa, leave
the power tool to acclimatise before
using it.
– If using adapters and tripods, ensure that
the power tool has been firmly screwed
down.
– Transport the power tool in the
appropriate transportation case only.
– If shipping the power tool or disconnec-
ting it for a prolonged period, isolate the
batteries or take them out of the power
tool.
Damage to the environment!
– Dispose of power tool, battery packs and
batteries in accordance with the currently
valid national directives. If in doubt,
contact the manufacturer or supplier.
Line laser