Water Drainage; Electrical Connection - AEG Electrolux LAVAMAT L 60890 Instrucciones Para El Uso

132984631_gb.qxd 14/10/2005
Installation

Water drainage

The end of the drain hose can be posi-
tioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch must be above the trap so that
the bend is at least 60 cm above the ground.
Directly into a
drain pipe at a
height of not
less than 60 cm
and not more
than
90 cm.
The end of the drain hose must always be ventilated, i.e. the inside
diameter of the drain pipe must be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked.
For a correct functioning of the machine the drain hose must
remain hooked on the proper support piece situated on the top
part of the back side of the appliance.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase,
50 Hz supply.
Check that your domestic electrical installation can take the maximum
load required (2.2 kW), also taking into account any other appliances in
use.
Connect the machine to an earthed socket.
The manufacturer does not accept any responsibility for damage or
injury through failure to comply with the above safety precaution.
84
09:51 Pagina 84