Teamtex Giordani orion 012 Manual De Instrucciones página 14

6.
Base
7. Blue lock-off clip (for rearward
facing use only)
8. Infant reducer cushion (some
models only)
9.
Adjustable headrest
10. Diagonal belt guides (x2 - for
rearward facing use only)
11. Red belt lock-off (x2 - for diagonal
belt (forward facing use only)
12. Lap belt guides (x2 - for forward
facing use only)
13. Lap belt guides (x2 - for rearward
facing use only)
14. Seat reclining lock
adJUSTinG THE HarnESSES
Make sure that the harness of your
car seat is adapted to the height of
your child before starting to install
the seat in your car. The height of the
headrest and the harness can be ad-
justed simultaneously, they should
be positioned just above the shoul-
der of the child. Loosen the wheel
on the head support (2), adjust the
head support to the desired height
(3), then tighten the wheel (4).
THE CorrECT TYPE oF SaFETY
BELT To USE WiTH YoUr Car SEaT
Your car seat must ONLY be installed
on a passenger seat fitted with a
3-point safety belt. NEVER install
your car seat on a passenger seat
fitted with a 2-point safety belt! (i -
0-10 kg) (i - 9-25kg)
rEarWard FaCinG USE
DO NOT USE THIS CHILD SEAT ON
A PASSENGER SEAT FITTED WITH A
FRONT AIR BAG! When used rear-
ward facing, the child seat must be
R285_ORION 012_70%.indd 14
(0 - 10 KG)
in the fully reclined position.
Pull lap and diagonal sections of
the car seat belt until fully extended
and feed both through the space be-
tween the shell and the base. Fasten
the seat belt. Thread the lap section
through the guides located at the
front of the base (5). Thread the di-
agonal strap through the two upper
guides located on the back of the
seat shell (6). Tighten the seat belt
by pulling first on the lap section,
then on the diagonal one (7). Check
that there are no kinks or twists in
the seat belt. Lock the 2 sections of
the belt with the blue lock-off clip.
The lock-off should be positionned
against the buckle of the seat belt
(8). Do not use the red lock-off for
the rearward facing installation. Al-
ways keep the seat in the most re-
clined position.
ForWard FaCinG USE
(9-18 KG)
It is not recommended to fit the
child car seat into a front seat
equipped with airbag. If you wish
to fit the child car seat in any seat
protected by airbag, always refer to
the vehicle instructions manual.
Fully recline the seat. Pull lap and di-
agonal sections of the car seat belt
until fully extended and feed both
through the space between the
shell and the base. Fasten the seat
belt (9).
Thread the lap section through the
guides located below the 2 red lock-
off clips. Open the 2 red lock-off clip
next to the buckle, then route the di-
agonal section of the belt through
the open lock-off clip (10). Push the
14
child
seat,
the se
direct
off ac
that t
the se
To fas
shoul
and in
shoul
the h
butto
• To t
adju
the
pres
IMP
ed h
chil
not
bet
chil
• To lo
adju
upp
the
neo
r
Undo
Positi
the ce
er (20
secon
strap
centra
crotc
keepe
slots
19/10/18 16:56