Harness Buckle; Fitting The Harness; Removing The Harness - Teamtex Giordani orion 012 Manual De Instrucciones

child seat right down into the car
ns of seat, and tighten both sections of
ended the seat belt by pulling the belt in the
direction shown (11). Close the lock-
ce be-
off across the diagonal belt. Check
asten
that there are no kinks or twists in
ection
the seat belt (12).
at the
he di-
upper
To fasten the harness, bring the two
of the
shoulder straps together (13) (14)
t belt
and insert them into the buckle; you
ction,
should hear a "click" (15). To release
Check
the harness, press the buckle's red
sts in
button (16).
ons of
f clip.

FiTTinG THE HarnESS

onned
• To tighten the harness: Pull on the
t belt
adjusting straps positioned on
off for
the harness. You do not need to
on. Al-
press on the adjuster buttons (17).
st re-
IMPORTANT:
ed harness is essential for your
child's protection. There should
not be more than finger's width
between the harness and your
t the
child.
seat
• To loosen the harness: Press on the
wish
adjuster buttons positioned on the
y seat
upper section of the harness, grasp
fer to
the lower section and pull simulta-
al.
neously (18).
nd di-

rEMoVinG THE HarnESS

t belt
Undo the harness if necessary (19).
both
Position the harness strap behind
n the
the central section of the seat cov-
e seat
er (20). Repeat the operation on the
second harness strap. The harness
h the
straps should be hidden under the
d lock-
central of the cover (21). Remove the
ff clip
crotch strap by twisting the metal
he di-
keeper and by passing it through the
rough
slots in underneath the plastic base
sh the
R285_ORION 012_70%.indd 15

HarnESS BUCKLE

A correctly adjust-
and the cover (22). Simply reverse
this procedure if you want to re-in-
stall the harness of your car seat.
ForWard FaCinG USE
(Gr.2 FroM 15 To 25 KG)
It is not recommended to fit the
child car seat into a front seat
equipped with airbag. If you wish to
fit the child car seat in any seat pro-
tected by airbag, always refer to the
vehicle instructions manual.
Make sure that you have removed
the harness of the car seat before
starting the installation. Follow the
instructions in the section entitled
'Removing the harness'. The car
seat must be set in its most up-
right position. Place the car seat in
a front-facing position on the rear
passenger seat of your vehicle and
sit your child in the car seat. Pull on
the seat belt until it is completely
loose. Thread the seat belt through
the openings on the side of the shell
and cover of the car seat (23). Pull
on the belt and threaded through the
openings on the opposite side of the
shell and cover (24). Fasten the seat-
belt (25). On the side nearest the
belt winder, pull up the diagonal belt
through the slot located on the side
of the shell (26). Make sure the belt
is not twisted and pull it as tightly as
possible (27). Check that the diago-
nal lies across your child's shoulder,
clear of its neck.
rECLininG YoUr CHiLd SEaT
Push the adjustment lever located
under the front of the seat upwards,
then pull or push the base towards or
away from you (28).
15
19/10/18 16:56