Perry DECRNN034 Instrucciones Para El Usuario página 17

6 - ATTACHING OR REMOVING THE CHRONOTHERMOSTAT FROM THE BASE
Fit the cable cover on by inserting the tooth
the base, then secure it by lightly pressing on the hooks
Use a small screwdriver to remove the cover by levering on each
hook in succession F.
F
E
Hook the chronothermostat onto the base, taking care to insert
the contacts correctly, then exert light pressure until you hear the
click of the attachment teeth.
D into the slot E in
F.
7- FITTING/REPLACING THE BATTERIES
When the
batteries are running out. From this moment, there are 30 days
D
to change them.
the indicated time, the display will turn off and the
remain constantly lit.
All thermoregulation operations are suspended and all settings are
saved to be restored when the new batteries are inserted.
Replace the dead batteries with two 1.5 V AA
batteries (LR6)
CAUTION
perform the operation without losing data
is about 1 minute
To remove the chronothermostat
from the base on the wall, grip it
as shown in the figure, then
extract it by turning it on the right-
hand side.
flashing symbol appears, this indicates that the
If the almost flat batteries are not replaced within
paying attention to their polarity.
: when changing batteries, the time available to
.
Dispose of flat
batteries in the
proper containers.
symbol will
alkaline Penlight
17