Perry DECRNN034 Instrucciones Para El Usuario página 21

11 - DISPLAY/MODIFY SET
TEMPERATURES
t COMFORT / t ECONOMY
The display normally shows room temperature detected
or current hours and minutes.
2 4
21 3
18 6
3
15 9
1 2
upon first start-up of the chronothermostat or after reset operation,
preset default temperatures are:
Comfort Temperature Set t = 20.0 °C / 68.0 °F (upper knob)
Economy Temperature Set 17.0 °C / 62.6
t =
In any chronothermostat operating condition, to display the current
settings, simply slightly turn the relative knob until the set itself
blinks. After 5 sec., the display will return to normal operation
visualisation. If settings do not meet user needs, it is possible to
modify them as desired at any time, from +5°C to +30 °C(from +41
°F to +86 °F), as per procedure shown to the side.
(via knobs):
Knobs can be
turned without
opening the cover.
t
°F (lower knob)
2 4
21 1 3
18 6
3
15 9
The desired Set starts to blink. Then, turn the knob
1 1 2
clockwise to increase or counter-clockwise to
2°
decrease (a variation of 0.1°C/0.1 °F at a time will
Indicates setting
be obtained).
modification
2 4
21 3
18 6
15 9
The temperature set
1 2
will thereby be the new
reference Set.
Note: if a temperature limit was set (see following para-
graph), the set value can be increased up to said limit
(blocked setting).
After 5 sec. from the last turn of the
3°
knob, the display will return to
regular operating conditions
Perform the same procedure to set the Seteconomy temperature
with knob t
Slightly turn the desired knob
1° t
( comfort or economy) to
v i e w t h e c u r r e n t S e t
temperature values and access
adjustment procedures.
2 4
21 3
+
18
15
9
1 2
2 4
21 1 3
18
3
15 9
1 1 2
6
6
21