Checking For Blockages; Nozzle Maintenance - Shark ROTATOR LIFT-AWAY LA500 Serie Guia Del Usuario

MAINTENANCE

NOZZLE MAINTENANCE

SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, carefully remove them.
CLEANING THE SOFT ROLLER
Slide the Soft Roller access button forward to
release the Soft Roller.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed. Use only
water, and allow it to air-dry completely for at
least 24 hours. Reinsert the Soft Roller in the
front of the nozzle until it clicks into place.

CHECKING FOR BLOCKAGES

DUST CUP BLOCKAGES
Detach dust cup from vacuum pod. Empty dust
cup and remove debris from lint screen in the top
of the dust cup.
HOSE BLOCKAGES
Detach hose from handle by pressing on the
release button at the top of the hose. Detach
the hose from the pod, and check openings
for blockages.
WAND BLOCKAGES
Detach wand from pod and handle, and check both
ends for blockages.
HANDLE BLOCKAGES
Detach handle from wand and check openings for
blockages.
s h a r kc l e a n . c o m