Checking For Blockages; Nozzle Maintenance; Cord Maintenance - Shark ZD400 Serie Guia Del Usuario

MAINTENANCE

NOZZLE MAINTENANCE

SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using setting II, Carpet mode,
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, clear them from
the brushroll.
DEBRIS WRAPPED
AROUND BRUSHROLL
Clean off any debris on the brushroll.

CORD MAINTENANCE

To minimize the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut off power to
the vacuum and remove the cord from the
brushroll or nozzle.
s h a r kc l e a n . c o m
DEBRIS IN NOZZLE HOSE
To clear debris and blockages from the
nozzle hose, open the locks on the bottom
of the nozzle. With a coin, turn the locks
counterclockwise to open, then lift the cover.
1. DO NOT pull or carry vacuum cleaner
by the cord or use cord as a handle.
2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around
sharp corners.
5. DO NOT leave the cord near
heated surfaces.

CHECKING FOR BLOCKAGES

HOSE BLOCKAGES
Detach hose from vacuum pod, and
check hose and opening on back of
pod for blockages.
NOZZLE BLOCKAGES
Check the opening at the top of
the nozzle for any blockages.
DUST CUP BLOCKAGES
Detach dust cup from vacuum pod.
Empty dust cup, remove debris from
lint screen, and check for blockages.
WAND BLOCKAGES
Detach wand from floor nozzle and handle,
and check both ends for blockages.
HANDLE/HOSE BLOCKAGES
Detach handle from wand and
hose from vacuum pod, and check
openings for blockages.
s h a r kc l e a n . c o m