Kohler K-7273 Guía De Instalación Y Cuidado página 6

Corte el tubo con la plantilla - Modelos especificados (cont.)
Con una sierra para metales, corte el tubo del rebosadero en la línea de corte para
rebosadero indicada en la plantilla de la línea de corte.
Elimine las rebabas del tubo de rebosadero.
2.
Cut Pipe without Template – Specified Models
Edge
Rebord
Filo
NOTE: It is not necessary to cut the waste pipe and overflow pipe for bath models
K-1152 and K-1153. Proceed to the "Assemble the Drain" section.
Waste Pipe
For Bath Models K-1190, K-1110, and K-1110 variations -AH, -CT, -G, -GCR, -M, and
-V:
With the edge of the tape measure flush against the edge of the waste body,
identify and mark 4-1/4" (10.8 cm) on the waste pipe.
Using a hacksaw, cut the waste pipe at the mark.
Remove any burrs from the waste pipe.
Overflow Pipe
For Bath Models K-1190, K-1143-L, K-1143-R, K-1110, and K-1110 variations -AH,
-CT, -G, -GCR, -M, and -V:
Bath Model
K-1110-M, K-1110-V
K-1190, K-1110, K-1110-AH, K-1110-CT, K-1110-G, K-1110-GCR
K-1143-L, K-1143-R
With the edge of the tape measure flush against the edge of the waste body, mark
the appropriate length of the overflow pipe based upon your bath model. Refer to
the table above for the appropriate cut length.
Using a hacksaw, cut the overflow pipe at the overflow cut line noted on the
cut-line template.
1089145-2-B
Cut Length
12-5/16" (31.3 cm)
13-13/16" (35.1 cm)
16-1/2" (41.9 cm)
6
Edge
Rebord
Filo
Kohler Co.