Symbol Explanation; Dear Customer; Symbols On The Machine - RedMax GZ380 Manual De Instrucciones

SYMBOL EXPLANATION

Dear customer!

Congratulations on your choice to buy a
RedMax chain saw!
Your purchase gives you access to profes-
sional help with repairs and service whenever
this may be necessary. If the retailer who
sells your machine is not one of our autho-
rized dealers, ask for the address of your
nearest servicing dealer.
It is our wish that you will be satisfied with
your product and that it will be your compan-
ion for a long time. Think of this operator's
manual as a valuable document. By following
its content (using, service, maintenance, etc.)
the life span and the second- -hand value of
the machine can be extended. If you ever
lend or sell this machine, make sure that the
borrower or buyer gets the operator's manual,
so they will also know how to properly main-
tain and use it.
Good luck on using your RedMax chain saw!
RedMax has a policy of continuous product
development and therefore reserves the
right to modify the design and appearance
of products without prior notice.

Symbols on the machine:

WARNING: Chain saws can be
dangerous! Careless or improper
use can result in serious or fatal
injury to the operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions
before using the machine.
Always wear:
S Approved protective helmet
S Approved hearing protection
S Protective goggles or a visor
Both of the operator's hands must
be used to operate the chain saw.
Never operate a chain saw
holding it with one hand only.
Contact of the guide bar tip with
any object must be avoided.
115391326 Rev. 3 1/31/11
WARNING: Tip contact may
cause the guide bar to move
suddenly upward and backward
(so-called kickback), which may
cause serious injury.
Measured maximum kickback
value without chain brake for the
bar and chain combination on
the label.
Other symbols/decals on the machine
refer to special certification require-
ments for certain markets.
You will find the following labels on your
chain saw:
The Emissions Compliance Period referred
to on the Emission Compliance label indi-
cates the number of operating hours for
which the engine has been shown to meet
Federal emissions requirements. Category
C = 50 hours, B = 125 hours, and A = 300
hours.
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any off- -road engine repair
establishment or individual.
English--- 6