H.Koenig HKM1028 Manual De Utilización página 8

• Setting the temperature :
Before you start cooking, choose the temperature. If you do not have to cook the ingredients,
go directly to the next point.
Press the TEMP. When the pictogram TEMP ▶ lights, press + to increase the temperature or
- to reduce. If you keep pressing the + or - button, the temperature will be increased or
decreased rapidly.
Press the button once to add or remove 10 °C.
The temperature of this appliance can be adjusted from 30 °C to 120 °C.
• Setting the speed of rotation of the blades :
Press the SPEED button. When the pictogram SPEED ▶ lights, press + to increase speed or
- to reduce.
Note: For mixtures, adjust the speed from 1 to 5. When you make the sauce or juice, adjust
the speed between 5 and 9.
• Start the appliance :
Press the START / STOP button. The appliance will start working. The time will begin to
count down to 0:00. Once the work is finished, the appliance will emit a beep. Press again
the START / STOP button to stop the appliance.
Important :
• When you do not choose to temperature or time but you just adjust the speed, the
appliance can be operated. Its maximum operating time is 20 minutes. After 20 minutes, the
appliance stops automatically and emits a beep to alert you.
• When using the cooking function, it is also necessary to set the time and speed. If you only
adjust the temperature but not the time or speed, the appliance will not work. When cooking
is finished, the time is 00:00. The appliance will stop heating but the blades will continue to
run for 10 minutes and stop with a beep so you do not burn the food by leaving it in the jug.
• When you choose the cooking mode, the maximum speed is 5.
• When the time reaches 0:00, the appliance will emit a beep. After 5 minutes, the appliance
will beep again if you ignore.
• Dough function (dough) :
Use this button to yeast or bread dough (the LCD will appear as in Figure 19).
Set first time and then press the button DOUGH. Then press the START / STOP button. This
function will trigger a preset program which operates in the following manner : Speed 3 for 3
seconds, stop for 4 seconds and then again speed 3 for 3 seconds, stop for 4 seconds etc ...
Fig 19
For example, put 500gr of flour in the jug (the jug must be dry and not contain water) and
better if you add a few drops of oil into the flour. When using a high gluten flour (for bread),
the amount of flour should not exceed 300gr.
Caution: At the end of the preparation of the dough, be careful when removing the blades to
avoid cuts. This appliance can move during the preparation of the dough. So put the
correctly place the jug on the appliance. Set the time to 3 minutes and
press the button DOUGH then the START / STOP button. The preset
program will start. At 1 minute of the end, pour 300 ml of water in the
jug. When the time reaches 0:00 you can remove dough.
Note: When using the paste function (Dough), the jug must be dry to
prevent sticking risks during mixing. Flour (cake) should not exceeded
500gr, water must not exceed 300ml and time should not exceed 3
minutes. The proportions of flour and water are 5/3. The result will be